Avaya 03-300430 User Manual

There are 2 ATM-EI circuit packs in each PN.

1. Enter status pnc at the SAT.  If the board is on the active side, enter reset pnc 

interchange to switch the active ATM-EI board to the standby side.

2. Enter busyout pnc-standby.
3. Enter busyout atm pnc # a-pnc or b-pnc.
4. Replace the circuit pack.

5. Enter release atm pnc #.
6. Enter release pnc-standby.
7. Wait 2½ minutes for board insertion.

8. Enter test board location, and verify that every test passes.

Note:

This section contains basic administration information only.  Refer to ATM 
Installation, Upgrades, and Administration using Avaya Communication Manager, 
555-233-124, for more detailed information.

ATM PNC connections involve administering

●

1 ATM-EI board in each PN (standard, duplex, or high reliability)

●

2 ATM-EI boards in each PN (critical reliability)

1. If the ATM-EI circuit pack is absent or if the circuit pack is present but in a PN, use the 

change circuit-pack command to add circuit pack translations.

2. Enter add atm pnc n (connection number), and administer the circuit pack’s location and 

its ATM address.

1. Enter change system-parameters duplication, and change the Enable Operation 

of PNC Duplication field to n.

2. If the ATM-EI circuit pack is absent or is present but in a PN that does not yet have PNC 

connectivity to it, use the change circuit-pack command to add circuit pack translation 

for the missing circuit pack.