Avaya 03-300430 User Manual

Notes:

a. Error Type 0: Run the short test sequence first.  If every test passes, run the long test 

sequence.  Refer to each appropriate test’s description, and follow its recommended 
procedures.

b. Error Type 2: The on-board DUART chip failed.  This results in communication failure 

between the PN’s Maintenance board and the ATM-EI board.  The Maintenance board 
should have a red LED lit, because the link to the ATM-EI is down in this PN.

1. Reset the board with reset board location.
2. If the board does not recover, replace the board.

c. Error Type 18: The ATM-EI circuit pack has been busied out.

1. Release the circuit pack (release board location).

d. Error Type 23: An ATM-EI circuit pack has been administered with the add atm pnc n 

command, but the circuit pack has not been inserted into the system.

1. Insert an ATM-EI circuit pack at this location.

e. Error Type 125: A wrong circuit pack is located in the slot where the ATM-EI circuit pack is 

logically administered.

1. Either remove the wrong circuit pack and insert the ATM-EI circuit pack or remove the 

ATM-EI administration (see 

2. Remove the ATM-INTF administration and re-administer the slot (change circuit-pack) to 

match the circuit-pack that is physically present in this slot.

3585 (

)

ATM Framer 

Looparound (#1260)

MAJ

ON

test board location l 

3586 (

)

ATM Framer 

Looparound  (#1260)

MAJ

ON

test board location l 

3841 (

)

3842 

(

3843 (

)

None

3999 (

)

Any

None

Any (

)

32767

None

 3 of 3