Avaya 03-300430 User Manual

Page of 2574
ATM-EI (Expansion Interface Circuit Pack)
Issue 1 June 2005
535
 
1088   
1104
ATM-EI circuit pack received a request with an 
invalid connection identifier.
Firmware-detected problems 
on the ATM-EI circuit pack.  
Note: Error Types 1088–1103 
are reported by the board that 
is originating the connection.  
Error Types 1104–1119 are 
reported by the board that is 
terminating the connection.  In 
most cases, when the 
terminating board reports one 
of these errors, the originating 
board also reports an 
ATM-NTWK error for the same 
event (usually with Error Type 
21).
1089   
1105
ATM-EI circuit pack received a request with a 
reference to an unknown VC token.
1090   
1106
ATM-EI circuit pack did not have enough 
resources (memory) for the requested operation.
1091   
1107
Internal failure in the local protocol stack.  This can 
occur when the connection to the ATM switch 
failed, perhaps because the:
ATM switch rebooted
fiber between the ATM switch and the 
ATM-EI circuit pack disconnected
1092   
1108
ATM-EI circuit pack received a request for which 
the referenced VC was in the wrong call state.
1093   
1109
ATM-EI circuit pack received a request for which 
the VPI/VCI pair was invalid or out of range.
1094   
1110
ATM-EI circuit pack received a request to add a 
party to an existing VC.  The add party request 
failed, and a retry was not possible.
1095   
1111
ATM-EI circuit pack in link recovery after the lower 
ATM layer (Q.SAAL portion of the protocol stack) 
failed.  This can occur when the connection to the 
ATM switch failed, perhaps because the:
ATM switch rebooted
fiber between the ATM switch and the 
ATM-EI circuit pack disconnected
1096   
1112
ATM-EI circuit pack received an error from the 
local protocol stack for which no more detailed 
cause was specified.
1102
ATM-EI circuit pack asked to create more 
connections that it was capable of creating.
1103
ATM-EI circuit pack detected an illegal message 
from software.
Check the Error Log for CONN-M proc errors for 
more information.
Table 170: ATM Error Types 1024 - 1151  (continued)
Error
Type
Description
General problem
 2 of 3