Avaya 03-300430 User Manual

1. If the system has duplicated PNC:

a. Test the ATM-EI (test board location l).
b. If Error 3585 is detected again, or if the board is not recognized anymore, replace the 

ATM-EI circuit pack.

2. If the system does not have duplicated PNC and the circuit pack is in a PN:

a. Replace the ATM-EI circuit pack.

Error Type 3586: Framer Looparound test (#1260) failed.

Aux Data (Error Code 3586 only):

3. If Error Type 3586 is detected again, replace the circuit pack.

v. Error Type 3841: The board received a message from the switch that it does not recognize, 

and the board responded with an inconsistent down link error message.  This error does not 
affect service, and no action is required.

w. Error Type 3842: The circuit pack received data from the packet bus faster than it could 

distribute the data to its endpoint.  This circuit pack should be able to recover by itself, and 
no action is necessary.

x. Error Type 3843: The firmware on the circuit pack is reporting a resource that is low.  This 

error does not affect service and no action is required.

y. Error Type 3999: The circuit pack sent a large number of control channel messages to the 

switch within a short period of time.

 

2

Packet path failed

3

Circuit path failed

4

TDM loop cannot be created

5

Packet loop cannot be created

Error Type 1538 is also 

present

Circuit pack is taken out of service 

Error Type 1538 is absent

Circuit pack is not taken out of service, but has generated 

50% of the messages necessary to be considered 

hyperactive.
This can be normal during heavy traffic.
If the error is logged during light traffic, it can indicate a 

problem with the circuit pack or the equipment attached to it.