Avaya 03-300430 User Manual

21

(

Call rejected.  This cause indicates that the equipment sending this cause 

does not wish to accept this call, although it could have accepted the call 

because the equipment sending this cause is neither busy nor 

incompatible.
Note: If the call was rejected by the far-end ATM-EI or ATM-CES board, 

there could also be additional information about this rejection in an ATM-EI 

error log entry.  Look for an ATM-EI or error with an Error Type between 

1104 and 1119 inclusive, with approximately the same time stamp as this 

error.

22

(

Number changed.  This cause is returned to a calling party when the called 

party’s number indicated by the calling user is no longer assigned.  The new 

called party’s number can optionally be included in the diagnostic field.  If a 

network does not support this capability, cause number 1 “unassigned 

(unallocated) number” is used.

23

(

User rejects every call with CLIR (calling line identification restriction).  This 

cause is returned by the called party when the call is offered without calling 

party’s number information and the called party requires this information.

27

(

Destination out of order.  This cause indicates that a user-indicated 

destination cannot be reached because a signaling message could not be 

delivered to the remote user over the destination’s interface (for example, a 

physical-layer or SAAL failure at the remote user, or remote user’s 

equipment is off line).

28

(

Invalid number format (address incomplete).  This cause indicates that the 

called user cannot be reached because the called party’s number is not in a 

valid format or has insufficient digits.

30

(

Response to STATUS ENQUIRY.  This cause is included in the STATUS 

message when the reason for generating the STATUS message was the 

prior receipt of a STATUS ENQUIRY message.

31

(

Normal, unspecified.  When no more specific cause values apply, this 

cause reports a normal event.

32

(

DTL transit not-my-node ID

35

(

Requested VPCI/VCI not available.  This cause indicates that the requested 

VPCI/VCI is not available.  This can be caused by mismatched VCI ranges 

on different ATM switches.

36

(

VPCI/VCI assignment failure

 2 of 6