Avaya 03-300430 User Manual

This test is not executed for ABRI-PORT/ATT-PORT/LGATE-PT/ATTE-PT because the B 
channels associated with the port are not used by ASAI or Avaya adjuncts.

1000

ABRT

System resources required to run this test are not available.  The port may 
be busy with a valid call.

1. Use display port location to determine the station extension or 

trunk group/member number of the port.  Use status bri-port 
location to determine the service state of the port.  If the service 

state indicates that the port is active, then the port is unavailable for 
certain tests.  (Refer to 

 in Maintenance 

Commands Reference (03-300191) for a full description of every 
possible state.) Wait until the port is idle before retesting.

2. If the port status is idle, then retry the command at 1-minute intervals up 

to 5 times.

3. If the test continues to abort, escalate the problem.

1004

ABRT

The port has been seized by a user for a valid call.

1. Use status station for the station associated with this port and 

determine when the port is available for testing.

2. Retry the command at 1-minute intervals up to 5 times.

3. If the test continues to abort and the port is idle, escalate the problem.

1005

ABRT

This test is not valid for this type of translation.  Ports administered as “ASAI” 

or “ADJK” cannot run this test, because the B channels associated with the 

port are not used by ASAI or Avaya Adjunct Links.  This is a normal 

condition.

2012

ABRT

Internal system error.

2100

ABRT

Could not allocate the necessary resources to run this test.

1. Retry the command at 1-minute intervals up to 5 times.

1, 2

FAIL

The NPE of the tested port was found to be transmitting in error.  This 
causes noisy and unreliable connections.  Error code 1 indicates that the 
NPE Crosstalk test failed on Channel B1.  Error code 2 indicates that the 
NPE Crosstalk test failed on Channel B1.

1. Replace the circuit pack.

 1 of 2