Avaya 03-300430 User Manual

2012

ABRT

Could not allocate the necessary system resources to run test.

1. Retry the command at 1-minute intervals up to 5 times.

2100

ABRT

Internal system error.

1. Retry the command at 1-minute intervals up to 5 times.

2. If the problem persists, escalate the problem.

1,
2

FAIL
FAIL

The buffer level is nearly exhausted.
The C-LAN is congested, and no buffers are available.

1. Retry command at 1-minute intervals up to 5 times.

2. If command continues to fail, examine the C-LAN port measurements 

to determine what ports are heavily utilized and the processor 
occupancy of the circuit pack.

Low processor occupancy when C-LAN congested indicates circuit pack 
failure.

1. If the problem persists, reset the circuit pack with reset board 

location.

2. If congestion recurs, replace the circuit pack.

High processor occupancy indicates the C-LAN is congested due to traffic 
load.

1. To relieve congestion in the short term, selectively busyout ports 

(busyout port location) on the Control LAN circuit pack.

2. To achieve a more permanent resolution, it may be necessary to move 

ports on this circuit pack to other Control LAN circuit packs.

3. Consider replacing affected C-LAN ports with new ports.

3

FAIL

The C-LAN circuit pack is not operating normally and is congested.

PASS

Hardware setting and attached cable type match C-LAN circuit pack 

administration.  The circuit pack detects no errors.

 2 of 2