Avaya 03-300430 User Manual

Note:

 / 

: This test aborts with Error Code 1412.

This test checks the reflective loop-around and conference capabilities of a CO port circuit.  The 
test uses 404-Hz, 1004-Hz, and 2804-Hz tones.  Each tone is transmitted separately through 
the loop and checked.

ABRT

Could not allocate the necessary system resources to run this test.

1. Retry the command at 1-minute intervals up to 5 times.

7

ABRT

Conference Circuit test aborted.

1. Retry the command at 1-minute intervals up to 5 times.

129

ABRT

The 404-Hz reflective loop-around test aborted.  Response to the test 
request was not received within the allowable time period.

1. Retry the command at 1-minute intervals up to 5 times.

131

The 1004-Hz reflective loop-around test aborted.  Response to the test 
request was not received within the allowable time period.

1. Retry the command at 1-minute intervals up to 5 times.

133

The 2804-Hz reflective loop-around test aborted.  Response to the test 
request was not received within the allowable time period.

1. Retry the command at 1-minute intervals up to 5 times.

1000

ABRT

System resources required to run this test are not available.  The port may 
be busy with a valid call.

1. Use display port location to determine the trunk group/

member number of the port.  Use status trunk to determine the 

service state of the port.  If the port is active, wait until it is idle before 
testing.

2. If the port status is active but the port is idle (no calls), check the error 

log for error type 769 (see the error log table for a description of this 
error and required actions).  The port may be locked up.

3. If the port status is idle, retry the command at 1-minute intervals up to 

5 times.

 1 of 4