Avaya 03-300430 User Manual

1000

ABRT

System resources required to run this test are not available.  The port may 
be busy with a valid call.

1. Use display port location to determine the trunk group/member 

number of the port.  Use status trunk to determine the service 

state of the port.  If the port is active, wait until it is idle before testing.

2. If the port status is idle, then retry the command at 1-minute intervals 

up to 5 times.

1001

ABRT

Could not allocate the necessary system resources to run this test.

1. Retry the command at 1-minute intervals up to 5 times.

1002

ABRT

The system could not allocate timeslots for the test.  The system may be 
under heavy traffic conditions or it may have timeslots out of service due to 
TDM bus errors.

1. If the system has no TDM bus errors and is not handling heavy traffic, 

retry the command at 1-minute intervals up to 5 times.

1004

ABRT

The port has been seized by a user for a valid call.  Use status trunk to 

determine when the port is available for testing.

1. Retry the command at 1-minute intervals up to 5 times.

1005

ABRT

Trunk has been administered as incoming-only; transmission tests can only 

be run on outgoing trunks.

1115

ABRT

The near-end test line on the TN771 circuit pack could not be allocated.

1. Verify that the TN771 circuit pack is in service and that port 1 is 

administered and in service with status port.

2. Retry the command at 1-minute intervals up to 5 times.

1900

ABRT

The test completion message was not received from the TN771 circuit 
pack.

1. Test the TN771 circuit packs.

1901

ABRT

This error occurs when the TN771 circuit pack uplinks a message that is 
not the proper response for this test.  The anticipated uplink messages are 
seize, ring or answer.

1. Verify that the trunk is administered properly.

 1 of 4