Avaya 03-300430 User Manual

The Conference Circuit test verifies that the NPE channel for the port being tested can correctly 
perform the conferencing function. The NPE is instructed to listen to several different tones and 
conference the tones together. The resulting signal is then measured by a tone detector port. If 
the level of the tone is within a certain range, the test passes.

ABRT

Could not allocate the necessary system resources to run this test.

1. Retry the command at 1-minute intervals up to 5 times.

1000

ABRT

System resources required to run this test are not available. The port may 

be in use on a valid call. Use status data-module to determine when 

the port is available for testing.

1004

ABRT

The port has been seized by a user for a valid call. Use status 
data-module to determine when the port is available for testing.

1. Retry the command at 1-minute intervals up to 5 times.

1020

ABRT

An existing Error Type #769 on this port prevented the test from running.

1. Follow the procedure following the Error Log Table for Error Type 

#769.

2000

ABRT

Response to the test request was not received within the allowable time 
period.

1. Rerun the test at 1-minute intervals up to 5 times.

2100

ABRT

Could not allocate the necessary system resources to run this test.

1. Retry the command at 1-minute intervals up to 5 times.

Any

FAIL

The conference circuit test failed (possible off-board problem).

1. Busyout and release the port (data line), and then retest.

2. Replace the circuit pack if the test continues to fail.

PASS

The port can correctly conference multiple connections. Investigate 

user-reported troubles on this port using other port tests and examining the 

ADU, external wiring, and customer equipment.