Avaya 03-300430 User Manual

Notes:

a. Error Type 0

: 

Run the short test sequence first. If every test passes, run the long test 

sequence. Refer to each test’s description, and follow its recommended procedures.

b. Error Type 1: DS1 Interface circuit pack or media module detects a hardware error on the 

DS1 DID trunk. The Aux Data field indicates the following:

Maintenance does not start any testing or generate any alarms in response to these errors.

c. Error Type 15 is a software audit error that does not indicate hardware malfunction. Run 

short test sequence, and investigate any errors.

d. Error Type 18: The trunk has been taken out of service by a demand busyout. No calls can 

be made on this trunk.

e. Error Type 130 indicates that the circuit pack or media module has been removed or has 

been insane for more than 11 minutes. To clear the error, reinsert or replace the circuit pack 
or media module.

f. Error Type 257: DS1 Interface circuit pack or media module detects a hardware error on 

the DS1 DID trunk. The Aux Data field indicate the source of the error:

g. Error Type 513: DS1 Interface circuit pack or media module detects a hardware error on 

the DS1 DID trunk. Aux Data 57392 indicates no external release on PBX disconnect.

h. Error Type 769: DS1 Interface circuit pack or media module detects a hardware error on 

the DS1 DID trunk. Aux Data 57393 indicates belated external release on PBX disconnect.

i. Error Type 1793: DS1 Interface circuit pack or media module is out-of-service. Look in the 

Hardware Error Log:

57476

On-hook before wink

57477

On-hook before ready to receive digits

57485

Wink too short for valid signal

57474

Rotary dial rate above 12 pulses per 

second

57473

Rotary dial rate below 8 pulses per 

second

TN767 DS1 Board

DS1-BD

TN464 UDS1 Board

UDS1-BD

 / 

: MM710 DS1 Media Module

MG-DS1