Avaya 03-300430 User Manual

1004

ABRT

The port was seized by a user for a valid call.

1. Use display port location to determine the trunk group/

member number of the port. Use status trunk to determine the 

service state of the port. If the port is in use, wait until it is idle before 
testing.

2. If the port status is idle, retry the command at 1-minute intervals up to 

5 times.

1020

ABRT

The test did not run due to a previously existing error on the specific port 
or a more general circuit pack error.

1. Examine Error Log for existing errors against this port or circuit pack 

and attempt to diagnose the previously existing error.

 /

1412

ABRT

This test does not execute on a G700 Media Gateway.

2000

ABRT

Response to the test was not received within the allowable time period.

1. Rerun the test at 1-minute intervals up to 5 times.

2100

ABRT

System resources required for this test are not available.

1. Retry the command at 1-minute intervals up to 5 times.

2053

ABRT

At least one of the following errors is found on the DS1 circuit pack 
(DS1-BD or UDS1-BD): 1281 – Loss of signal, 1793 – Blue Alarm, 2049 – 
Red Alarm, 2305 – Yellow Alarm, or 1537 – Hyperactivity

1. Resolve any of the previous error types.

ANY

FAIL

This can be due to off-board problems, including EXP-PN and EXP-INTF 
faults, RMC-ENV faults (

), TDM-BUS faults, and Tone Detectors/

Tone Generators. Clear every off-board problem before replacing the 
board. A TDM-BUS problem is usually a faulty board or bent pins on the 
backplane.

1. Resolve any EXP-PN, EXP-INTF, RMC-ENV (

), TDM-BUS, 

TONE-BD, and TONE-PT errors in the error log.

2. Retest when errors are cleared. Replace the board if the test fails.

PASS

The port is correctly using its allocated time slots. Investigate user-reported 

troubles on this port using other port tests and by examining station, trunk, 

or external wiring.

 3 of 4