Avaya 03-300430 User Manual

This test checks a port’s battery feed circuitry for on-/off-hook detection, battery shutdown, and 
battery reversal (wink) capabilities.

ABRT

System resources required to run this test were not available.

1. Retry the command at 1-minute intervals up to 5 times.

1000

ABRT

System resources required to run this test were not available. The port 
may be busy with a valid call.

1. Enter display port location to determine the trunk group/

member number of the port. Use status trunk to determine the 

service state of the port. If the port is in use, wait until it is idle before 
testing.

2. If the port status is active but the port is idle (no calls), check the error 

log for Error Type 513. The port may be locked up.

3. If the port status is idle, busyout and release the trunk, and retry the 

command at 1-minute intervals up to 5 times.

4. If the test continues to abort, check for wiring errors toward the CO 

which may cause the trunk to lock up.

5. If the wiring is good and the test continues to abort, replace the circuit 

pack or media module.

1004

ABRT

The port was seized by a valid call during the test.

1. Enter display port location to determine the station extension, 

attendant number, or trunk group/member number of the port. Use 
status station, status attendant, or status trunk to 

determine the service state of the port. If the port is in use, wait until it 
is idle before testing. Attendants are always in use (off-hook) if the 
handset is plugged in and the port is not busied out.

2. Retry the command at 1-minute intervals up to 5 times.

1018

ABRT

Test disabled via administration. Verify that the Maintenance Tests field on 

the Trunk Group form is set to n. To enable the test, enter change 

trunk-group x, where x is the trunk group number. Change the entry in 

the Maintenance Tests field to y.

 1 of 3