Avaya 03-300430 User Manual

1006

ABRT

The port is out of service, perhaps busied out.

1. Use display port location to determine the trunk group/member 

number of the port. Use status trunk to determine the service state 

of the port. If the port is out of service, wait until the port is in service 
and idle before testing.

2. If the port status is in service and idle, then retry the command at 

1-minute intervals up to 5 times.

2100

ABRT

Could not allocate the necessary system resources to run the test.

1. Retry the command at 1-minute intervals up to 5 times.

FAIL

Internal system error

1. Retry the command at 1-minute intervals up to 5 times.

PASS

This test passed. Translation information was successfully updated on the 
circuit pack or media module.

1. If signaling troubles are reported (Error Types 1, 257, or 513), verify 

translation for this port.

2. Refer problem to the CO.

If the trunk is busied out, the test does not run, but returns PASS. To verify 
that the trunk is in-service:

1. Enter status-command to verify that the trunk is in-service. If the 

trunk is in-service, no further action is necessary. If the trunk is 
out-of-service, continue to Step 2.

2. Enter release-trunk to put trunk back into in-service.
3. Retry the test command.

0

NO 

BOARD

The test could not relate the internal ID to the port.

1. Verify that the board’s translations are correct. Translate the board if 

necessary.

2. Enter busyout board location
3. Enter reset board location
4. Enter release board location
5. Enter test board location

This should re-establish the linkage between the internal ID and the 
port.

 2 of 2