Avaya 03-300430 User Manual

14

MAJ

“upsAlarmDepletedBattery” — If primary power is lost, the UPS could not 
sustain the current load.

1. Charge or replace the batteries in the UPS, according to procedures in 

its Site Preparation, Installation, and Operator’s Manual, 167-405-035.

15

MAJ

“upsAlarmBatteryBad” — One or more batteries needs to be replaced.

1. Replace any defective batteries in the UPS, according to procedures in 

its Site Preparation, Installation, and Operator’s Manual, 167-405-035.

16

MIN

“upsAlarmInputBad” — An input condition is out of tolerance.

1. Provide appropriate AC power to the UPS.

17

MIN

“upsAlarmTempBad” — The internal temperature of a UPS is out of 
tolerance. (On the UPS, the “over temperature” alarm indicator flashes, 
and the UPS changes to Bypass mode for cooling. Either:

1. Look for and remove any obstructions to the UPS’s fans.

2. Wait at least 5 minutes, and restart the UPS.

3. Check for and resolve any fan alarms (Event ID 25) against the UPS.

4. Either:

●

Change (increase or decrease) the environment’s temperature.

●

Change the alarming thresholds.

18

MIN

“upsAlarmCommunicationsLost” — The SNMP agent and the UPS are 
having communications problems. (A UPS diagnosis may be required.)

1. Behind the UPS in its upper left-hand corner, verify that an SNMP card 

(with an RJ45 connector) resides in the UPS — instead of a serial card 
with DB9 and DB25 connectors.

2. Verify that the server is physically connected to the UPS via the RJ45 

connector.

3. Verify that the SNMP card is properly administered according to the 

procedures in its users guide, provided by the vendor.

4. If necessary, replace the SNMP card in the UPS.

5. If the problem persists, replace the UPS, and diagnose it later.

 2 of 4