Avaya 03-300430 User Manual

1004

ABRT

The port was seized by a valid call during the test.

1. Enter display port location to determine the station extension 

or attendant number of the port. Use status station or status 
attendant to determine the service state of the port. If the port is in 

use, wait until it is idle before resetting. Attendants are always in use 
(off-hook) if the handset is plugged in and the port is not busied out.

2. Retry the command at 1-minute intervals up to 5 times.

1005

ABRT

The installed circuit pack does not support this operation.

 /

1412

ABRT

This test does not execute on a G700 media gateway.

2000

ABRT

Response to the test was not received within the allowable time period.

1. Retry the command at 1-minute intervals up to 5 times.

2100

ABRT

System resources required to run this test are not available.

1. Make sure terminal is connected and repeat test.

2. If test fails replace terminal and repeat test.

3. Retry the command at 1-minute intervals up to 5 times.

14

FAIL

The primary channel is not operating properly. User impact may range 
from noticing nothing to not being able to use the port.

1. Check the results of “Voice and Control Channel Local Loop test 

(#13).

2. If that test fails, suspect the Digital Line circuit pack. If that test passes 

then replace the terminal.

3. If both tests fail, and component replacement does not change the 

results, then:

a. Run circuit pack tests to check the tone generator circuit and the 

Tone Detector circuit using test board location.

b. Resolve any problems that are detected on the Tone Generator 

circuit or Tone Detector circuit.

1015

ABRT

The station is not busied out (busyout station).

 2 of 3