Bosch FW5.50 User Manual

en | Basic Mode

Camera Browser Interface

AM18-Q0611 | v5.50 | 2012.03

Software manual

Bosch Security Systems

Use the settings on this page to integrate the device into a 

network. Some changes only take effect after a reboot. In this 

case, the Set button changes to Set and Reboot.

1.

Make the desired changes.

2.

Click Set and Reboot.

–

The device is rebooted and the changed settings are 

activated. If the IP address, subnet mask, or gateway 

address is changed, then the device is only accessible 

under the new addresses after the reboot.

If the network has a DHCP server for dynamic IP address 

allocation, set this parameter to On to activate the automatic 

acceptance of DHCP-assigned IP addresses.

For certain applications, the DHCP server must support the 

fixed assignment between IP address and MAC address, and 

must be appropriately set up so that, once an IP address is 

assigned, it is retained each time the system is rebooted.

Enter the desired IP address for the camera. The IP address 

must be valid for the network.

Enter the appropriate subnet mask for the set IP address.

Enter the IP address of the gateway to establish a connection to 

a remote location in a different subnet. Otherwise, this field can 

remain empty (0.0.0.0).