Acu-Rite 08552W Leaflet

1. Open the flashlight by twisting the  

    cap counter clockwise.

2. Remove the plastic sleeve containing 

(4) “LR 41” button cell batteries.

3. Remove the batteries from the plastic 

sleeve, making sure to note the 

orientation of the batteries before 

removing them from the sleeve.

4. Place (4) new batteries into the 

plastic sleeve, making sure that each 

new battery is facing “-“ side up.

5. Replace the plastic sleeve with the 

new batteries into the flashlight, with 

the “+” side facing down and the “-“ 

terminal facing up.

6. Replace the cap by twisting it 

clockwise, making sure not to 

overtighten.

model 08551W, 08552W, 08553W

BATTERY SAFETY: Follow the polarity (+/-) diagram in 

the battery compartment. Promptly remove dead batteries from the device. Dispose of used batteries properly. Only batteries of 

the same or equivalent type as recommended are to be used. DO NOT incinerate used batteries. DO NOT dispose of batteries in 

fire, as batteries may explode or leak. DO NOT mix old and new batteries or types of batteries (alkaline/standard). DO NOT use 

rechargeable batteries. DO NOT recharge non-rechargeable batteries. DO NOT short-circuit the supply terminals. Battery contains 

mercury. Do not put in trash. Recycle or manage as hazardous waste.

 Contact Customer Support at 

(877) 221-1252 or visit www.AcuRite.com.

Congratulations on your new AcuRite product. To ensure the best 

possible product performance, please read this manual in its 

entirety and retain it for future reference.

4 x "LR 41" (included)

Please note that the carabiner flashlight 

ships with a plastic safety insert located in 

the battery compartment. This safety insert 

helps conserve energy while the product 

is being stored, packaged and shipped. 

Simply remove the small plastic insert so 

that the carabiner flashlight will be able to 

function properly.  
1. Twist the cap of the flashlight assembly 

counter clockwise.

2. Remove the small plastic disc that covers 

the battery sleeve.

3. Replace the cap by twisting clockwise, 

making sure not to over-tighten.

NOTE: Carabiner Flashlight is not intended for load-bearing 

activities and should not be used for climbing.
1. To power on the flashlight, twist the cap clockwise until the light 

illuminates.

2. To power off the flashlight, twist the cap counter clockwise until 

the light shuts off.

Printed in China

This Carabiner Flashlight is not designed for load-bearing 

activities and should not be used for climbing.