Bosch 8500 User Manual

Video Output Modules

EN | 17

7.3

Video Output Modules

Counting from left to right beginning with slot 9, install the appropriate number of 
Video Output Modules (VOM) into these slots. If fewer than the maximum number 
of VIMs are installed, there will be empty slots between the Input and the Output 
Modules, so make sure that the Output Modules are inserted into the correct slots.

Figure 4: Typical Video Output Module Insertion

All VOMs are identical and are interchangeable within the designated VOM slots.

7.4

CPU Module

The slot to the left of the power supply in the main CPU bay is reserved for the sys-
tem CPU module.

NOTE

The CPU module contains two (2) lithium batteries mounted on the component 
side of the printed circuit board. A red rectangular insulating tag may be 
installed in between the top of the batteries and the battery holder clip. This tag 
prevents battery drainage during stocking. Remove tag if so equipped.

Figure 5: Typical CPU Module Insertion

Install the main bay CPU at this time.

The circuit board contains two (2) 8-position DIP switches for system configuration 
options. The DIP switches can be used to modify certain system operating condi-
tions. Review the Factory Default Settings Section to determine if it is necessary to 
change the DIP switches from the factory default positions. For reference, the fac-
tory default settings are: