Bosch D1265 User Manual

D1265 | Owner's Manual | Part II: System Commands 

 

 

Bosch Security Systems, Inc. | 9/10 | F01U169130-02 

25

 

6.  Move through this list by pressing the 

Next Pt 

button.  

 

The display changes to show the information for 
that point. 
Press the 

Exit button to return to the ### points 

remain to be tested screen before continuing 
with the walk test. 

7.  When all points have been tested, 

0 points 

remain to be tested is shown. 

Press the 

Exit button. 

The display momentarily shows 

All points have 

been tested. 
The display then shows idle text. 

Reset Sensors (CMD + 4 + 7) 

Description 

Detection devices, such as smoke detectors and shock 
sensors, must be reset after being activated. This 
function momentarily removes power from these 
sensors to reset them.  

Using Reset Sensors 

1.  Ensure the display shows disarmed idle text. 

2.  Press the 

CMD button. The display shows 

*System Command*. 

 

3.  Press the 

4 button, followed by the 7 button. 

 

If you prefer, you might use the function 
list in place of Steps 2 and 3 to initiate 
this function. 

Press the Menu button to enter the 
function list. 

Press the Next button repeatedly. 

When you reach the Reset Sensors 
button, press it. 

 

4.  The display shows for approximately 15 sec. 

 

While the sensors reset, the keypad resets 
before it returns to idle text. 

If you enter this function and the detector or sensor 
resets momentarily, but then returns to a faulted 
condition, the conditions causing the activation might 
still be present or the detector might be faulty. Check 
to be certain that there is no smoke, fire, or other 
danger present. If you can’t reset the detector or 
sensor, contact your security company.