Bosch D1260B User Manual

D1260/D1260B | Owner's Manual | Part II: System Commands - Entering a Passcode

Bosch Security Systems | 9/04 | 50410D

Part II: System Commands

Below is a summary of the commands covered in this
section.

Some of these functions may not be
available in your system. Please consult
your security company to determine which
commands have been made available to
you.

If you attempt to enter a function that’s not available or
if the function is available in the system but your
passcode is not authorized to perform the function,
then

**No Authority**

will display on the Keypad.

Press the

COMMAND key and then the one or two

digits shown in the table below to perform the function.
When you use a command to perform a function, the
displays in the function list below do not appear at
your keypad.

Some commands listed below may not be
available. Contact your security company
for more information.

Table 2: Keypad Commands

COMMAND Function

Master Arm

Master Arm Instant

Perimeter Instant

Perimeter Delay

Silence Trouble Sounder & Clear
Trouble Display

View Memory

Walk Test

Reset Sensors

Watch Mode

Special Alert

Perimeter Partial

Special Alert

Walk Test

Entering a Passcode

The display may prompt you to enter your
passcode.

The passcode is shown as asterisks (*) when
entered and advance from the right side of the
display to the left until all passcode digits (from a
minimum of 3 to a maximum of six) are entered.

Press

ENTER.