Bosch D1260B User Manual
D1260/D1260B | Owner's Manual | Part III: Advanced Commands -
Bosch Security Systems | 9/04 | 50410D
63
2.
Press the
COMMAND key. The display shows
*System Command*
.
3.
Press the
5 key and then the 9 key.
If you prefer, you may use the Command
Menu in place of steps 2 and 3 to initiate
this function.
Menu in place of steps 2 and 3 to initiate
this function.
Press the MENU> soft key to enter the
Command Menu.
Command Menu.
Press NEXT> soft key repeatedly.
When you reach the DISPLAY REV ?>
prompt, press its adjacent soft key.
prompt, press its adjacent soft key.
4.
The display will change to Radionics D9412*
Version 6-40
Version 6-40
(D9412 and 6-40 are used as an example, other
panels could be D9112, D7412, D7212)
panels could be D9112, D7412, D7212)
5.
The display will return to idle text after 5 seconds.
SERVICE MENU ? (9 + 9 + Enter)
The service menu is used to access the following
commands:
commands:
•
View Log - Use this function to review events in
your system at your command center. Reviewing
past events may help you identify problems.
Viewing events does not require any additional
equipment since the information is displayed at
your command center. Events are stored in the
panel’s memory in order of occurrence and tagged
with the date and time.
your system at your command center. Reviewing
past events may help you identify problems.
Viewing events does not require any additional
equipment since the information is displayed at
your command center. Events are stored in the
panel’s memory in order of occurrence and tagged
with the date and time.
•
Print Log - The Print Log function lets you print
the events stored in your security system’s log. You
can choose to print the entire log or set a start date
and print the events recorded from that date up to
today. Your system must include a parallel printer
interface and a printer to perform this function.
the events stored in your security system’s log. You
can choose to print the entire log or set a start date
and print the events recorded from that date up to
today. Your system must include a parallel printer
interface and a printer to perform this function.
•
Display Rev (COMMAND + 5 + 9) - The
command will retrieve the panel’s software version
and display it.
command will retrieve the panel’s software version
and display it.
•
Service Walk (D9412/D9112 only) – The
command will allow all the points on the system to
be walk tested regardless of the type of point. For
D7412 and D7212 panels this function must be
added to the keypad’s menu. Contact your security
company for more information.
command will allow all the points on the system to
be walk tested regardless of the type of point. For
D7412 and D7212 panels this function must be
added to the keypad’s menu. Contact your security
company for more information.
•
Default Text – This command will show the
current state of the area for 3 seconds before
returning to idle text.
current state of the area for 3 seconds before
returning to idle text.
1.
Ensure your keypad shows idle disarmed text.
2.
Press the
9 key twice.
3.
Press the
ENTER key.
4.
The display changes to show the service menu.
Service Walk Test?>
appears on D9412/D9112
Panels only