Bosch 3.5 User Manual

Bosch Security Systems | 2011-02

Praesideo 3.5 | Installation and User Instructions | 9 | System Configuration

en | 323

40

Configuration software

40.1 Introduction

The network controller is equipped with a web 
interface. The web interface is accessible using the 
configuration PC connected to the network controller 
and can be used to configure and diagnose the 
Praesideo system.

40.2  Starting and logging on

Proceed as follows to log on to the web interface:
1 Start a web browser program on the configuration 

PC.

2 Enter the IP address of the network controller in the 

address bar. A screen similar to the one in figure 40.1 
appears.

3 Select a language for the web interface at the bottom 

of the page.

4 Click the Continue button to access the web interface. 

A screen similar to the one in figure 40.2 pops up.

5 Enter the user name in the User Name field, enter the 

password in the Password field and click OK to open 
the web interface. A screen similar to the one in 
figure 40.3 appears.

40.3 Overview

The web interface (see figure 40.3) contains the 
following elements:
•

Configure - A button that opens the configuration 
section of the web interface (see section 40.4).

•

Diagnose - A button that opens the diagnostics 
section of the web interface (see section 50).

Note
The web interface is not factory installed on the 

network controller. Putting the web interface on 

the network controller is part of the software 

installation process (see chapter 35).

Note
The default user name is admin, the default 

password is admin. The password can be 

changed by adding a new user with 

administrator rights and then deleting the 

default user (see section 41.3 and 41.4).