Petsafe PPA11-10709 User Manual

To reduce error while programming, remove the RFA-67 battery from all programmed SmartKeys

™

 

except the one you are programming. Press and hold the LEARN button until the green light 

illuminates and begins to fl ash, now release the button. Bring the SmartKey

™

 directly below the 

green light and the light will stop fl ashing and illuminate for two seconds. Now your new SmartKey

™

 

has been programmed and added to memory. Up to fi ve different SmartKeys

™

 can be added, one at 

a time.

A split key ring has been provided to attach to your pet’s 

collar and should hang under the pet’s neck. 

The SmartDoor

™

 includes (one) SmartKey

™

 which comes 

pre-programmed and ready to use. 

OPERATE

    

LOCKED MODE – Does not allow entry or exit for any pet. The SmartDoor

™

 ships from the factory 

in LOCKED MODE and when batteries are placed in the SmartDoor

™

, it will enter LOCKED MODE. To 

set: hold the MODE-RESET button until the red light illuminates and release when selected. 

UNLOCKED MODE – Allows entry and exit for all pets. To set: hold the MODE-RESET button until 

the green light illuminates and release when selected.  

AUTOMATIC MODE – Allows entry and exit for a pet wearing a programmed SmartKey

™

; up 

to fi ve SmartKeys

™

 can be programmed into one SmartDoor

™

 for selective entry and exit during 

automatic mode. To set: hold the MODE-RESET button until the yellow light illuminates and 

release when selected. 

NOTE: 

If at any time the red light remains illuminated, replace with a set of fresh batteries. If that 

does not reset the red light, please call our Customer Care Center for additional help.

RED

Solid only for two seconds after 

selecting LOCKED Mode

LOCKED Mode

Flashing

Low battery alert

Constant solid

Internal failure has occurred

GREEN

Solid only for two seconds after 

selecting UNLOCKED Mode

UNLOCKED Mode

Flashing

Learn Mode

YELLOW

Solid only for two seconds after 

selecting AUTOMATIC Mode

AUTOMATIC Mode

Flashing

Error alert

RED, GREEN AND YELLOW Flashing at the same time

Sensitivity Test Mode

SmartDoor

™

 does 

not respond to the 

presence of the 

SmartKey

™

 when my 

pet is directly in front 

of the SmartDoor

™

 

within three seconds

• Check that the SmartDoor

™

 is in AUTOMATIC Mode.

• Check that the SmartKey

™

 has been programmed to the SmartDoor

™

. 

• Check sensitivity level has been properly set, see page 10. 
• Check that the RFA-67 battery in the SmartKey

™

 is screwed in tightly.

• Check that the batteries in the SmartDoor

™

 are fresh.

• If the condition persists, check that there are no radio-frequency 

transmitting devices or electronic devices that radiate electrical 

energy, which may interfere with the operation of the SmartDoor

™

.