Petsafe PPA11-10709 User Manual

1. With a Phillips screwdriver, remove the two Battery 

Compartment Cover screws.

2. Remove the Battery Compartment Cover.
3. Refer to the inside of the Battery Compartment 

Cover for the proper orientation of the four D-Cell 

(LR20) batteries. 

4. Replace the Battery Compartment Cover and re-

install the two screws.

5. When the batteries are placed in the Electronic 

SmartDoor

™

 the red light will illuminate for 

two seconds and the fl ap will move into the 

locked position, unless the fl ap is already in the        

locked position. 

NOTE:

 The door must be in the upright position for     

the fl ap to center properly and operate correctly.

1. Place the PetSafe

®

 RFA-67 battery into the bottom of 

the SmartKey

™

.

2. Using a coin, rotate one-quarter turn clockwise to 

secure the PetSafe

®

 RFA-67 battery.

NOTE: 

The SmartKey

™

 has a red light that will fl ash 

when the PetSafe

®

 RFA-67 battery is low; the battery 

should be replaced as soon as possible.

•  To check if operational settings are working properly, hold down the MODE-RESET button 

until each operational mode has cycled through once to allow red, green and yellow lights to 

illuminate one at a time.

LOCKED MODE – Does not allow entry or exit for any pet. The SmartDoor

™

 ships from the 

factory in LOCKED MODE and when batteries are placed in the SmartDoor

™

, it will enter 

LOCKED MODE. To set: hold the MODE-RESET button until red light illuminates and release 

when selected.  
UNLOCKED MODE – Allows entry and exit for all pets. To set: hold the MODE-RESET button 

until the green light illuminates and release when selected.