NuTone PFC-48II Leaflet

WARNING:  To reduce the risk of personal injury, do not bend the
blade brackets when installing the brackets, balancing the blades,
or cleaning the fan. Do not insert foreign objects in between rotating
fan blades.

WARNING: To reduce the risk of fire, electric shock, or personal
injury, mount to outlet box marked “Acceptable for Fan Support” and
use mounting hardware provided with the box.

WARNING: To reduce the risk of fire, electric shock, do not use this
fan with any solid-state speed control device.

This product must be mounted and wired in compliance with all local
and national electrical codes.

Before wiring the ceiling fan, turn off electric power at the circuit
breaker or fuse box and leave off until installation is complete.

Mount outlet box so that it will support at least 35 pounds.

Note: the weight of the fan is as follows:

PFC-48  14 lbs.

PFC-56  20 lbs.

1. When fan is installed, you must allow a minimum of 10 feet be-

tween floor and bottom of fan blades.

2. For this model, the center of the fan must be located at least 32”

from any vertical surface - wall, doors, partitions, etc. This allows
minimum clearance for fan blades.

3. Do not mount fan below, next to or between air ducts, beams or

any other obstructions which may interfere with the natural air flow
pattern created by the fan.

4. Place fans near constantly opening doors and shipping bays to

produce an  “air shield” effect that helps keep out cold air in winter
and dust, odors and insects in the summer.

5. If desired, fans can be installed directly above heat producing

machinery to reclaim the heated air.

6. For maximum air flow, fans should be located above aisles in

warehouses and storage areas.

7. Make sure fan voltage is compatible with your electrical system.

8. FOR SLOPED CEILING INSTALLATIONS ONLY: Ball and socket

mounting system will work on sloped ceilings up to 22° maximum
(rise/run = 5/12).

Photo shows

hardware included

with your new

ceiling fan.