Monte Carlo Fan Company 5OR52XXD User Manual

Place blade holders onto blades aligning holes in

blade holder with holes in blade.  Make sure that the

side of the blade you select is facing downward.

Install  3 screws and fiber washers to back side of

blade as shown.  Tighten screws securely. Repeat

this process 4 more times until all blades are assem-

bled.

Install blades to motor using the 10

motor screws provided.  Tighten

screws securely.

Lift fan to mounting bracket, aligning the “L”

shape holes on the canopy with the screws on

the mounting bracket.  Turn the fan  clock-

wise to lock in position.  Re-install the screws

removed in the previous step and tighten

securely.

Remove switch cap housing from fan.

Remove the plug from center of fit-

ter. Install switch cap housing to light

kit by turning clockwise to tighten.

Remove nut and save for next step.

Remove the all thread studs from the lower

part of the mounting bracket. 

Hang fan

from mounting bracket by the hands

free hook into a closed hole on the

edge of the Canopy.   Note: For

Canadian mounting refer to Step #8.

Hands free hook

Take 4 screws from hardware pack

and insert 2 one on each side of

bracket to match the L slot screw

holes in canopy.  Keep 2 screws for

later use. 

Replace the 3 screws removed and

tighten securely. Check motor for

shipping stabilizers and remove if

present.

Place canopy over fan body

aligning holes.

Make wire connections to power source using wire nuts
provided.  Make sure that no filiments are outside of
the wirenut. After making the wire connections, the
wires should be spread apart with the grounded con-
ductor and the equipment-grounding conductor on one
side of the outlet box and ungrounded conductor on
the other side of the outlet box.  

Connect black and blue wire from fan to Black or (Hot)

wire from house.  Connect White wire from Fan to

White (Neutral) wire from house.  Connect Ground

leads from mounting bracket and downrod to Ground

lead from house.  Refer to Safety Tips section of

Blue 

Black

White

Green

Black

White

Ground

Install keeper nut over lead wires.