Mellerware 35100 User Manual

1  Read all instructions before using the fan heater.

2  Only connect the fan heater to a single-phase socket 

with main voltage as specified on the rating plate.

3  This appliance meets the electromagnetic 

compatibility requirements specified in EN 55104/95 

with regard to interference with radio and TV sets.

4  Do not leave your home while the appliance is in 

use. Ensure that the switch is in the OFF (0) position 

and that the thermostat is in the minimum position. 

Always unplug the appliance.

5  Keep combustible material such as furniture, 

cushions, bedding, paper, clothes, curtains etc. at 

least 100cm away from the fan heater.

6  If wall mounted do not fix to combustible material 

such as wooden, synthetic or plastic surfaces. Do 

not hang anything on or in front of the fan heater.

7  Always unplug the heater when not in use. Do not 

pull the cord to unplug the heater.

8  Keep the air inlet and outlet free from objects; at least 

1m in front and 50cm behind the heater.

9  Do not install the heater below an electical socket.

10  Do not let children or animal touch or play with the 

fan heater. Pay attantion! The air outlet gets hot 

during operation (more than 80°C).

11  Do not cover, if covered there is a risk of overheating.

12  Do not use the fan heater in the immediate 

surroundings of a bath, shower or swimming pool.

13  Do not use the fan heater in rooms with explosive 

gas or while using flammable solvents, varnish or 

glue.

14  In case the power cord is damaged send it to the 

nearest after sale service recommended by the 

supplier for the replacement.

•  This appliance requires no installation and should be 

used soley as a portable device.

-   Turn the thermostat knob (right) in a clockwise 

direction until it reaches the maximum setting.

- 

Summer service (ventilation only): turn the knob to 

fan setting

- 

Heating at reduced power; turn the thermostat 
knob (right) to setting 

 (1000w)

- 

Heating at full power; turn the thermostat knob 
(right) to setting 

 (2000w)

- 

Switching off; turn the switch knob (left) to setting 0.

•  When the room has reached the desired 

temperature, turn the right thermostat knob in an 

anti-clockwise direction up to where the appliances 

switches off and not beyond.

•  The temperature is “fixed” in this way and will be 

automatically regulated and kept at a contant level 

by the thermostat.

•  Before cleaning always remove the plug from the 

electrical socket.

•  Clean the air intake and outlet grilles frequently.

•  Never use abrasive solvents or powders.

•  Do not use the heater to dry laundry.

•  Never obstruct the intake and outlet grilles (danger of 

overheating).

•  The appliance must be positioned so that the 

switches and other controls can not be reached by 

children or persons using the bath tub or shower.

•  In case the power cord is damaged send it to the 

nearest after sale service recommended by the 

supplier for the replacement.

•  Do not use in rooms with less than 4m² floor area.

•  The heater is fitted with a safety device which 

will switch the appliance off in case of accidental 

overheating. (eg: obstruction of air inlet and outlet 

grilles, motor turning slowly or not at all.)

•  To reset, disconnect the plug from the mains power 

for a few minutes, remove the cause of overheating 

then plug the appliance in again.