Toro 5800 Leaflet
Multi Pro
®
5800
Initial Console Programming
The console will require programming upon initial setup or any time the controller system values must be reset
to their default settings. When turning the console power on for the first time, the console will flash “CAL” in
the RATE display. This indicates that the console must be programmed before it can be operated. Once the
console is programmed, the “CAL” indicator will stop flashing and the values will be stored in memory.
Turning the power ON/OFF switch to the “OFF” position will not affect the stored values.
to their default settings. When turning the console power on for the first time, the console will flash “CAL” in
the RATE display. This indicates that the console must be programmed before it can be operated. Once the
console is programmed, the “CAL” indicator will stop flashing and the values will be stored in memory.
Turning the power ON/OFF switch to the “OFF” position will not affect the stored values.
STEP 1: Selecting US (Acres), SI (Hectares) or TU (1,000 sq. ft.)
A. Momentarily depress until you reach the desired setting. (US, SI or TU)
B. Once the desired setting has been reached, momentarily depress
to lock in your selection.
STEP 2: Program Keys
Program keys 1-8 (top row of the Console) using the key reference on the reverse side.
FOLLOW THESE STEPS:
Note: Reset the console system settings by turning power switch to the OFF position, depress
and hold while turning the power switch ON
and hold while turning the power switch ON
If an entry selection is made in error during steps 1 & 2, simply reset the Console.
CE
CE
ENTER