Gianni Industries DG-15 Series User Manual

DG-15 series Digital Keypad Entry system

Operation User's Manual

1. Specifications:

Operating Voltage: 12 Vdc

Current Draw: Average 15mA, Peak 100mA @ 12Vdc

Input: request-to-exit, time out reed switch contact

Output: Dual relays, N.O./N.C./Com. Output (free voltage
contact)

Relays Electric Current: 2A MAX @30Vdc ；0.4A @
120Vac

Relay Activation Time:

Relay 1 time delay setting code「＊30」、Relay 2
setting code「＊31」

Strike Time: 1~99 seconds（adjustable）

Strike mode: Access Timer or Latch

Memory Volume: 20+1 PIN codes

Relay 1 is controlled by ＊01~＊20 user slots

Relay 2 is controlled by ＊21 user slots

Operating Temperature: -20~+70℃

Ambient Humidity: 5~95% relative humidity non-condensing

Factory Master Code: 12345

Invalid PIN Lock-out: The system will shut down for 60 seconds while 30 codes of
incorrectly Master Codes enrolled or PIN codes attempted（None beeper signal of
keypad activations）.

EPROM: Non-volatile memory, System will retain all programs and codes after a total
loss of power.

The indicator signal chart:

LED signal

Sound signal

Green LED

Power on, stand-by

1 Beep

Effective PIN codes、Any key pressed

Red LED

Relay 1 activated

2 Beeps

Entering 、Exiting from the Program mode

Yellow LED

Relay 2 activated

3 Beeps

Data computing error

Beeps

Master Code reset to Factory （12345）

2. Operation Instruction:

Enter Program Mode:

1. Compose twice the master code (4 digit format press「1234」、5 digit format press

「

12345」) → 2 beeps → you are now in the "programming mode".

2. After 60 seconds if you have not entered any codes or data, the system will

automatically exit from the programming mode.

Exiting from the program mode:

1. Press「#」 to exit from the programming mode.
2. After 30 wrong codes attempts at the master code the lockout facility will operate.

Add PIN codes

Enter the Programming mode, Enter the slot position code 「＊01~＊20」→????? Input
5 digit （or 4 digit）PIN codes→ (beep) enrolled Æ（repeat）
Press 「#」 to exit from the programming mode, or program other operating.

Note 1:

The codes「0000」,「00000」,「1234」,「12345」or master code are not be

used for PIN code.

Note 2:

Relay 2 is controlled by ＊21 user slots

To Delete a User Code：