Thermo Products CMC1-75DV3N User Manual
All installations and services must be performed by qualified service personnel.
VI. INSTALLER'S INSTRUCTIONS TO USER:
After completing the installation, the installer shall inform and/or demonstrate to the
homeowner:
homeowner:
1. The location of all the instructions in the furnace and that the instructions must
be kept along with instructions for any accessories in the plastic pouch.
2. The location and use of the manual gas shut off valve and furnace electrical
disconnect switch. Instruct user to always shut off gas before shutting off electric
power.
3. The sequence of operation of the furnace.
be kept along with instructions for any accessories in the plastic pouch.
2. The location and use of the manual gas shut off valve and furnace electrical
disconnect switch. Instruct user to always shut off gas before shutting off electric
power.
3. The sequence of operation of the furnace.
4. The correct operation and maintenance of the appliance as outlined in this
manual.
5. That failure to maintain and operate this furnace in accordance with these
instructions could result in hazardous conditions, bodily injury, property damage
and may void the limited warranty on the furnace.
6. Review with and encourage the user to read the label reproductions and all
warnings and instructions in this manual.
7. Recommend that the user have a qualified heating contractor inspect the
furnace at the start of each heating season. Inform the user of the frequency of
inspection required for each component.
8. Should the furnace not operate after installation – note diagnostic code
through view port prior to removing door.
manual.
5. That failure to maintain and operate this furnace in accordance with these
instructions could result in hazardous conditions, bodily injury, property damage
and may void the limited warranty on the furnace.
6. Review with and encourage the user to read the label reproductions and all
warnings and instructions in this manual.
7. Recommend that the user have a qualified heating contractor inspect the
furnace at the start of each heating season. Inform the user of the frequency of
inspection required for each component.
8. Should the furnace not operate after installation – note diagnostic code
through view port prior to removing door.
VII. DEALER MAINTENANCE
The following maintenance procedures should be performed at the beginning
of each heating season by a qualified heating contractor. Correct any
deficiencies at once.
of each heating season by a qualified heating contractor. Correct any
deficiencies at once.
: Personal injury or property damage could result from repair or
service of this furnace by anyone other than a qualified heating contractor.
: To avoid injury from moving parts, shut off the power to the
furnace before removing blower compartment door.
:
Label wires prior to disconnection when servicing controls. Wiring
errors can cause improper and dangerous operation.
48