Euro-Pro S3601CO User Manual
4
TOLL FREE:
1-800-798-7398
5
English
www.sharkclean.com
IMPORTANT: Your Steam Mop needs
water to make steam! Never use your
steam mop without water in the tank.
water to make steam! Never use your
steam mop without water in the tank.
Sweep or vacuum your floors prior to
cleaning with your Steam Mop.
cleaning with your Steam Mop.
Visit
www.sharkclean.com for other
great quick cleaning products to
complement your Steam Mop, such
as the
complement your Steam Mop, such
as the
Shark
®
Navigator
(model NV350).
Getting Started - cont’d
IMPORTANT: Don’t use on unsealed
wood or unglazed ceramic floors.
On surfaces that have been treated
with wax or some no wax floors,
the sheen may be removed by
the heat and steam action. It is
always recommended to test an
isolated area of the surface to be
cleaned before proceeding. We
recommend that you check the use
and care instructions from the floor
manufacturer.
wood or unglazed ceramic floors.
On surfaces that have been treated
with wax or some no wax floors,
the sheen may be removed by
the heat and steam action. It is
always recommended to test an
isolated area of the surface to be
cleaned before proceeding. We
recommend that you check the use
and care instructions from the floor
manufacturer.
2
Use the lavender loop on the side of
the micro-fiber cleaning pad to slide
mop head into pad pocket. Then
secure the quick fasteners on the top
of the pocket to lock in place.
(
mop head into pad pocket. Then
secure the quick fasteners on the top
of the pocket to lock in place.
(
fig. 2)
3
Snap the mop head into the base to
secure it. (
fig. 3)
4
Turn the water tank cap counter
clockwise and remove from the tank.
(
(
fig. 4)
Use the filling flask and pour water
into the tank. Please don’t overfill.
Replace the cap on the water tank.
(
into the tank. Please don’t overfill.
Replace the cap on the water tank.
(
fig. 5)
1
Pull and twist the quick release cord
holder to unwrap the power cord
completely. Plug into a 120-volt
electrical outlet. (
completely. Plug into a 120-volt
electrical outlet. (
fig. 6)
2
The
ON/STANDBY switch will
flash blue. If the light does not turn
on, reference the troubleshooting
section on page 12. (
fig. 7)
IMPORTANT: Make sure you don’t
use the mop without attaching a
micro-fiber cleaning pad and adding
water to the tank first. When you are
using the mop for the first time, it
might take longer than the normal 30
seconds to start steaming.
use the mop without attaching a
micro-fiber cleaning pad and adding
water to the tank first. When you are
using the mop for the first time, it
might take longer than the normal 30
seconds to start steaming.
Using Your Steam Mop
fig. 2
fig. 3
fig. 6
fig. 7
fig. 4
fig. 5
S3601CO_IB_110117.indd 4-5
1/17/11 4:28 PM