Skylink 18TR Leaflet

®

In this package, you will find a keychain transmitter with 12V alkaline battery,
a garage door receiver, a red / black wire and a mounting bracket.

The following instructions will show you how to install the receiver. After
installing, the keychain transmitter (already programmed to the receiver)
can be used to operate your garage door opener.

You need to locate 2 things inside your garage to install the receiver:
1) the wall-mounted door control;
2) an electrical outlet, select an electrical outlet different from the one

already connected to the power cord of the garage door opener to
reduce the chance of interference. The further distance between
the receiver and the garage door opener, the less interference
between 2 devices.

Remove the wall-mounted door control from the wall by removing
the screws. Connect the stripped ends of the Red/Black wire to the
2 terminals (2 screws) on the back of the wall mounted door
control. (Polarity does not matter.)

Unplug the power cord of your garage door opener before
installation to ensure power is not connected.

Wall Mounted
Door Control

Electrical
Outlet

Remove power cord of garage
door opener before installation.

A: - Ensure when the button on the transmitter is pressed, the red light on the

transmitter comes on. Otherwise, check if the battery is inserted properly.

- The left button on the transmitter should be pressed, not the right button
- If the red light on the receiver flashes when you press the appropriate

button on the transmitter, but the door opener does not respond, please
ensure the red/black wire is successfully connected from the receiver to
the wall mounted door control.

- Ensure the wires that are previously connected to the wall mounted door

control are not loose.

- Ensure the transmitter has been programmed to the receiver. Refer

to section 4 for how to program a transmitter to the receiver.

The transmitter in this kit has been programmed to the receiver in the
factory.  You need to do the programming only if you add additional
transmitters to the receiver.

Plug in the connector end of the Red/Black wire to the 18R
receiver. Note the orientation of the male & female connector.

Plug the receiver into an electrical outlet inside the garage.
The red light on the receiver should be on after being plugged into an
electrical outlet.

Re-connect the power cord of the Garage Door Opener.

The Left button on the transmitter has been programmed to operate
the receiver.  Activate this button will trigger the receiver therefore
opens the garage door.