Genie 4064H User Manual

NOTICE

IF DOOR

 BECOM

ES OBS

TRUCTE

D

PULL DO

WN ON

 HANDLE

TO RELEASE SHUTTLE:

1.  Pull DOWN on handle and let go.

2.  Raise or lower door manually.

DOOR

PULL

TO ENGAGE SHUTTLE:

1.  Pull DOWN on handle and let go.

2.  Raise or lower door using remote or wall console.

Use Release Handle to manually connect or release 

Shuttle from carriage and screw drive shaft.

 

 

•   Observe all safety warning and precautions! 

Improper light bulb removal or replacement 

could result in Death or Serious Injury.

•   Disconnect power from opener before 

beginning this task.

•   When replacing light cover, make sure wires are 

not pinched or near moving parts.

1. Disconnect power to door opener.

•  Open powerhead light cover.
•  Remove light bulb(s).
•  Replace with maximum 100 Watt light bulb(s).

– Do NOT use light bulbs with greater than 

100 Watt rating.

•  Close powerhead light cover.

2. Reconnect power to door opener.

•  Test light operation. 

©2010     The Genie Company 

12/2010

19

Performing all ten (10) Limits/Force setting steps 

(pages 6-7) erases previous Limits/Force settings.

Powerheads equipped with a motion detector 

sensor provide additional security when 

exiting or entering the garage area. 

*This sensor works by detecting body heat.  Range of detection may be 

reduced when the temperature in the garage is close to body temperature.

NOTE: Detector positioning on the powerhead provides 

for monitoring below the powerhead.

•  Detector sensor is always ON.  There are NO user 

controls or adjustments.

•  Lights automatically turn ON when a change is 

detected and will turn OFF after 4 minutes of no 

change.

•  Motion detector sensor will not turn OFF lighting 

turned ON at the wall 

console

.

•  Lighting turned ON at the wall console will remain 

ON until wall 

console

 turns lighting OFF or opener 

is used.

Motion Detector