Bacharach 24-9351 User Manual
Instruction 24-9351
PCA
3.0 SETTING UP THE PCA
3.1 Scope
Before using the PCA, you MUST:
• Check the batteries or plug in an optional Power Supply (Section 3.2)
• Connect the probe to the analyzer (Section 3.3)
• Check the analyzer’s configuration (Section 3.4)
• Connect the probe to the analyzer (Section 3.3)
• Check the analyzer’s configuration (Section 3.4)
3.2 Power
3.2.1 Checking and Replacing the Batteries
A fresh set of batteries is supplied with the PCA. Install the batteries as
described below. Check for a sufficient charge prior to each use. If a
LOW BATTERY message is displayed, replace the batteries.
described below. Check for a sufficient charge prior to each use. If a
LOW BATTERY message is displayed, replace the batteries.
1. Remove the battery cover from the back of the PCA (Figure 3-1).
2. Remove (and properly dispose of) the old batteries.
3. Install a new set of four AA alkaline batteries, making sure to prop-
erly orient them as indicated by the “+” and “–” terminals in the
battery compartment.
battery compartment.
4. Replace the battery cover.
Figure 3-1. Battery Replacement
3-1
Setup