Regency P121LC User Manual
Regency
®
P121-2/P121LC-2/P121RC-2/P131-2 Zero Clearance Direct Vent Gas Fireplace
28
INSTALLATION
LOG INSTALLATION
Read the instructions below carefully and refer to the diagrams. If
logs are broken do not use the unit until they are replaced. Broken
logs can interfere with the pilot operation.
logs are broken do not use the unit until they are replaced. Broken
logs can interfere with the pilot operation.
Log Kit # 360-930 contains the following pieces:
a) 326
Front Right Log
b) 327
Front Left Log
c) 328
Middle
Right
Log
d) 329
Middle
Left
Log
e)
Embers
902-154
326
Push back side of the left end of the log up
against the tab on the burner.
326
326
327
Grate Post
1) Carefully remove the logs from the box and unwrap them. The logs
are fragile, handle with care - do not force into position.
2) Place Log 326 on the front right side of the burner. Ensure that the
notches on the far right side of the log fi t into the grate posts. Push
back side of the left end of the log up against the tab on the burner.
back side of the left end of the log up against the tab on the burner.
Repeat step 2 on the opposite side of the burner.
Tab on Burner
3) Place Log 327 on the front left side of the burner. Position the right
end of the log in between the two tabs and the left end of the log into
the grate post.
the grate post.
328
327
329
326
The image below shows all of the logs in place.
326
329
328
327
The 3-digit numbers (ie. 327) are
molded into the rear of each log.
326
327
329
328
Please note that there are 2 of each log. This log
set is mirrored front and back.
set is mirrored front and back.