Regency P33-NG4 User Manual

Regency

®

 P33-4 Zero Clearance Direct Vent Gas Fireplace

31

The standard fl ush door comes with a black 
frame. To install the frame, simply hook the top 
door fl ange onto the top of the unit and swing 
the door towards the unit, diagram 1. Be careful 
that the glass gasket does not roll up; there must 
be a gap between the gasket and the door lip to 
ensure that the door sits securely on the unit. 
See Diagram 2.

6)  Place the bottom left front edge of Log 251 

against the left edge of  the burner tray and 
rest the log on the cutout on Log 253.

7)  Position Log 252 across the cutouts in  Logs 

254 and 253. The notch in the bottom right 
end fi tting against the 5th grate tab.

8)  Pull off ember size pieces of rockwool and 

gently place them on the front of the burner 
tray in the places shown in the photo below. 
Do not compress the rockwool, leave it 
loose.

9)  Test fi re to ensure proper light off (make 

sure fl ame fl ows smoothly from one end of 
burner to the other).  If there is any fl ame 
hesitation, check that area for any blockage 
of the burner ports.   

10) Install fl ush glass and bay glass (if used) as 

per instructions in this manual.

Use the hook to pull the spring out until you 
can put the hook into the slot on the bottom 
door bracket. Repeat for 2nd spring. See 
diagram 3.

To remove the fl ush door, reverse the above 
steps.

Attach the round magnets to the back of the 
top trim piece and to the bottom trim piece, 
then attach trim to the top and bottom of 
Flush door.