Regency L900-LP User Manual
Regency
®
L900 Direct Vent Gas Fireplace
15
INST
ALLA
TION
INSTALLATION
VENTING ARRANGEMENTS
HORIZONTAL TERMINATION (FLEX)
Regency
®
Direct Vent System
These venting systems, in combination with the L900, have been tested and listed as a direct vent system by Warnock Hersey. The location of the
termination cap must conform to the requirements in the Vent Terminal Locations diagram from the "Exterior Vent Termination Locations" section.
termination cap must conform to the requirements in the Vent Terminal Locations diagram from the "Exterior Vent Termination Locations" section.
FPI Direct Vent (Flex) System Termination Kits include all the
parts needed to install the L900 using a fl exible vent.
parts needed to install the L900 using a fl exible vent.
8” dia.
Flue pipe
5” dia. flue pipe
spring spacer
Termination Cap
AstroCap XL
TM
(Part #946-623/P)
Vent Guard - if required*
(Part #946-506/P)
Wall Thimble
(Mandatory in all
Horizontal Terminations)
Vinyl Siding
Standoff
Notes:
1) Liner sections should be continuous without any joints
1) Liner sections should be continuous without any joints
or seams.
2) Only Flex pipe purchased from FPI may be used for Flex
installations.
3) Horizontal vent must be supported every 3 feet.
4) A wall thimble is mandatory for all horizontal terminations
due to high temperatures.
FPI Kit #
Length
Contains:
#946-618
6 Feet
1)
8” fl exible liner (Kit length)
2)
5” fl exible liner (Kit length)
3) spring
spacers
(3)
4) thimble
(2)
5)
AstroCap termination cap (1)
6) screws
(12)
7)
tube of Mill Pac (1)
8) plated
screws
(8)
9)
S.S. screws #8 x 1-1/2” drill point, (4)
10) vinyl siding standoff
#946-616
10 Feet
* A Vent Guard is required when the AstroCap
is installed above grade at 7 feet or lower.
is installed above grade at 7 feet or lower.