Regency P48-2 User Manual

Regency

®

 P48-2 Zero Clearance Direct Vent Gas Fireplace

1)  Unhook the 2 spring loaded hooks from the bottom of  the fl ush door 

and lift the Flush Front off the unit.

2)  Unwrap the brick pattern panels from the protective wrapping.

  a)  Loosen the two screws from the bottom of the baffl e plate. Install 

the bottom clips onto the baffl e plate (refer to Diagram 1).

5)   Place the top bracket onto the front edge of the top panel (refer to 

Diagram 5).

6)   Slide the top panel and bracket assembly carefully onto the baffl e 

plate ensuring the panel is centered. Make sure the tabs of the top 
bracket fi t into the baffl e openings  (refer  to Diagrams 6 & 7). The 
back of the top brick panel sits on top of the bottom clips.

3)  Insert the back brick panel fi rst by carefully slipping it between the 

back wall of the fi rebox and the rear log bracket (refer to Diagram 2).

4)  Put the side panels in next. Tilt them in towards the middle of the 

fi rebox and put the bottom front corner in fi rst. Be very careful not 
to scratch them on the fi rebox hardware. Place them fl at up against 
the wall, they should fi t snugly against the top of the fi rebox (refer to  
Diagrams 3 & 4).