Regency U41-NG3 User Manual

Regency U41-3 ULTIMATE Gas Fireplace Insert

1) Install both center and side glass onto

extrusions as per diagram.

2) Place glass assembly into door frame.

3) Install retainers by placing 1 drop of glue

where previously glued and put in place.

4) Install side retainers.

5) Install door catch plate.

6) Install the 24 nuts loosely, do not tighten yet.

7) Tighten side panels nuts using the following

procedure:

a. tighten top &

bottom outside
corner nuts (2)

b. tighten inside

nuts (3)

c. tighten top &

bottom inside
corners (2)

Your Regency stove is supplied with high
temperature, 5 mm Neoceram ceramic glass
that will withstand the highest heat that your
unit will produce. In the event that you break
your glass by impact, purchase your replace-
ment from an authorized Regency dealer only,
and follow our step-by-step instructions for
replacement.

The unit should never be used with broken logs.
Turn off the gas valve and allow the unit to cool
before opening door to carefully remove the
logs. The pilot light generates enough heat to
burn someone. If for any reason a log should
need replacement, you must use the proper
replacement log. The position of these logs
must be as shown in the diagram under Log
Installation.

The 24 carat gold plated finish on the door
requires little maintenance, and need only be
cleaned with a damp cloth.  DO NOT use
abrasive materials or chemical cleaners, as
they may harm the finish and void the warranty.
Clean any fingerprints off  before turning the
unit on.  If gasket seal is not tight - door
may discolour.

If the door gasket requires replacement use 7/
8" diameter oval door gasket (Part # 650-920).
The glass requires 5/8" flat glass gasket (Part
# 936-243). See your Regency Dealer.

The door latch may require adjustment as the
door gasket material compresses after a few
fires and after glass
replacement. Turn the
adjustable latch to tight-
en or loosen the latch.

8) Tighten the 10 nuts on center glass retain-

er.

9) Repeat step 7 for other side panel.

10) Replace new gasket by gluing it in place.

11) Install door onto stove and check the seal.

1) Remove the door from the unit and place on

a soft surface to prevent scratching.

2) Pull out the door gasket.

3) Remove the nuts holding the glass retain-

ers in place.

4) Remove the glass retainers (sides, top and

bottom) and the door catch plate.

5) Replace the glass. The glass must have

6) Reverse the previous steps, replace the

retainers and fasten with the nuts but do
not overtighten, as this can break the glass.
Note: the  door catch plate fits on top of the
left side retainer.

7) Put gasket glue on the retainers, but do not

put glue on the screws. Replace the door
gasket, the two ends butt tight together on
the bottom edge of the door.

8) Replace door on the stove and check the

seal.

1) Remove the door from the unit and place on

a soft surface to prevent scratching.

2) Pull out the door gasket.

3) Remove the 24 nuts holding the glass retain-

ers in place. Do not remove the nuts under-
neath the retainers.

4) Remove the door catch plate.

5) Remove glass retainers on sides first (3

each side) then remove two center retain-
ers.

6) Remove glass from extrusions. When re-

moving center glass, leave white insulation
in place.