Regency U35-LP1 User Manual

U35 FPI Direct Vent Gas Insert

2)  Unplug or disconnect power source to 

stove.

3)  Remove glass front (See the "Standard Flush 

Door" section).

4) Remove logs.

5)  Remove brick panels, if used.

6)  Straighten the adjustment wire under the 

fi rebox base.

If your fan requires maintenance or replacement, 
access to the fan is through the plate on the 
fl oor of the fi rebox. NOTE: the unit MUST NOT 
be operated without the fan access panel 
securely in place.

1)  Turn the unit off and allow it to cool to room 

temperature.

1)  Remove the door from the unit and place 

on a soft surface to prevent scratching.

2)  Remove the nuts holding the glass clips in 

place and remove.

3)   Replace the glass. The glass must have 

5)  Reverse the previous steps, replace the 

glass clips and fasten with the nuts but 
do not over tighten, as this can break the 
glass.

6)  Replace door on the stove and check the 

seal. 

7)  Remove the Burner/Rear Log Support 

assembly by removing the 2 screws (1 on 
each side) and sliding the assembly to the 
left to free the bottom brackets from the 
screws on the fi rebox base.

8)  Lift the Burner/Rear Log Support assembly 

up and away from the orifi ce.

9)  Remove the 8 screws holding the Access 

Panel in place.

Your FPI insert is supplied with high temperature, 
5 mm Neoceram ceramic glass that will withstand 
the highest heat that your unit will produce.  Do 
not abuse the glass by striking the surface or 
by slamming the door shut.

If your glass requires cleaning, we recommend 
using an approved glass cleaner available at 
all authorized dealers. Do not use abrasive 
materials. Do not clean the glass when 
hot.

In the event that you break your glass by 
impact, purchase your replacement from an 
authorized FPI dealer only, do not use substitute 
materials. Follow our step-by-step instructions 
for replacement. Caution: Wear gloves when 
removing damaged or broken glass.

Remove the fl ush door front. Remove the 4 
glass clips from each corner. Slide in the new 
replacement glass. Push the 4 glass clips back 
onto the frame.