Quadra-Fire 7051-158B User Manual
Page 6
7051-158B
December 6, 2011
R
EDGE 60 Pellet Fireplace
A. Appliance Certifi cation
C. Glass Specifi cations
F. BTU & Effi ciency Specifi cations
This appliance is equipped with 5mm ceramic glass. Replace
glass only with 5mm ceramic glass. Please contact your
dealer for replacement glass.
glass only with 5mm ceramic glass. Please contact your
dealer for replacement glass.
This appliance is approved for mobile home installations
when not installed in a sleeping room and when an outside
combustion air inlet is used.
when not installed in a sleeping room and when an outside
combustion air inlet is used.
The structural integrity of the mobile home fl oor, ceiling, and
walls must be maintained.
walls must be maintained.
The appliance must be properly grounded to the frame of
the mobile home and use only Listed pellet vent Class “L”
or “PL” connector pipe.
the mobile home and use only Listed pellet vent Class “L”
or “PL” connector pipe.
A Quadra-Fire Outside Air Kit must be installed in a mobile
home installation. You must order the Outside Air Kit sepa-
rately.
home installation. You must order the Outside Air Kit sepa-
rately.
B. Mobile Home Approved
NOTICE: This installation must conform with local codes.
In the absence of local codes you must comply with the
ASTM E1509-04, ULC S627-00, (UM) 84-HUD and
ULC/ORD-C-1482.
In the absence of local codes you must comply with the
ASTM E1509-04, ULC S627-00, (UM) 84-HUD and
ULC/ORD-C-1482.
D. Electrical Rating
115 VAC, 60 Hz, Start 5 Amps, Run 1.25 Amps
*BTU will vary, depending on the type of fuel you use in
your fi replace. Consult your Quadra-Fire dealer for best
results.
your fi replace. Consult your Quadra-Fire dealer for best
results.
NOTICE: Hearth & Home Technologies, manufacturer
of this appliance, reserves the right to alter its prod-
ucts, their specifi cations and/or price without notice.
of this appliance, reserves the right to alter its prod-
ucts, their specifi cations and/or price without notice.
Model
EDGE™ 60 Pellet Fireplace
Laboratory
OMNI Test Laboratories, Inc.
Report No.
061-F-75-6.2
Type
Solid Fuel Room Heater/Pellet Type
Standard
ASTM E1509-04, ULC S627-00 and
ULC/ORD-C1482 Room Heater Pellet
Fuel Burning type and (UM) 84-HUD,
Mobile Home Approved.
ULC/ORD-C1482 Room Heater Pellet
Fuel Burning type and (UM) 84-HUD,
Mobile Home Approved.
FCC
Complies with Part 15 of FCC Rules.
Operation is subject to the following
two conditions: (1) this device may not
cause harmful interference, and (2) this
device must accept any interference
received, including interference that
may cause undesired operation.
Operation is subject to the following
two conditions: (1) this device may not
cause harmful interference, and (2) this
device must accept any interference
received, including interference that
may cause undesired operation.
Emissions Rating:
EPA Compliance
BTU Input*:
14,620 - 52,000 / hr
Effi ciency:
83.3%
Heating Capacity:
2,400 - 3,800 square feet depend-
ing on climate zone
ing on climate zone
Hopper Capacity:
120 lbs
Fuels:
Pellets, Shelled Field Corn, Wheat
and Black Sunfl ower Seeds
and Black Sunfl ower Seeds
Shipping Weight:
450 lbs (empty hopper)
Weight with Full
Hopper:
Hopper:
add approximately 120 lbs
Quadra-Fire is a registered trademark
of Hearth & Home Technologies.
of Hearth & Home Technologies.
WARNING! Risk of Fire! Hearth & Home Technologies dis-
claims any responsibility for, and the warranty and agency
listing will be voided by the below actions.
claims any responsibility for, and the warranty and agency
listing will be voided by the below actions.
DO NOT:
• Install or operate damaged appliance
• Modify appliance
• Install other than as instructed by Hearth & Home
Technologies
• Operate the appliance without fully assembling all
components
• Overfi re
• Install any component not approved by Hearth &
Home Technologies
• Install parts or components not Listed or approved.
Improper installation, adjustment, alteration, service or
maintenance can cause injury or property damage.
maintenance can cause injury or property damage.
For assistance or additional information, consult a qualifi ed
installer, service agency or your dealer.
installer, service agency or your dealer.
1
Listing and Code Approvals
E. Outside Air Kit
Outside Air is required on all installations. You must order
the Outside Air Kit separately.
the Outside Air Kit separately.
Note: The appliance is also approved for installation
into a shop.
into a shop.