Quadra-Fire 7051-158B User Manual

R 

December 6, 2011

7051-158B

Page  9

Changing to Different Fuel Type

•  Empty the hopper of the previous fuel
•  Thoroughly vacuum hopper before fi lling with the new 

fuel

•  Select the appropriate setting on the FUEL SELECTION 

screen on the thermostat wall control

The burn rate, BTU content and heat output will all vary 
depending on the fuel selected.

Storage

•  Wood pellets should be left in their original sealed bag 

until using to prevent moisture absorption.

•  Shelled corn, wheat or sunfl ower seeds should be stored 

in a tight container to prevent it from absorbing moisture 
from damp or wet fl oors.  

•  This will also prevent rodents from becoming a problem.

•  Do not store any pellet fuel within the clearance 

requirements or in an area that would hinder routine 
cleaning and maintenance.

The appliance is like most modern furnaces; when the 
thermostat wall control calls for heat, your appliance will 
automatically light and deliver heat.  

When the room is up to temperature and the wall control is 
satisfi ed the appliance will shut down.  

In the automatic setting the heat output level is controlled by 
the wall control.  Select “Automatic” on the AUTO/MANUAL 
screen.  Figure 9.1.

When you select “Manual” on the AUTO/MANUAL screen the 
appliance will still automatically turn on and off according to 
the temperature setting.  

However, you will be able to manually control the heat output 
levels.  Adjust the heat output levels by using the HEAT 
OUTPUT LEVEL screen.  Figure 9.2.

Automatic

Manual
Off

Medium

Your appliance is equipped with an automatic fi repot cleaning 
system that will change the frequency of cleaning based on 
the fuel being burned.  

The auto-clean system will clean itself immediately on initial 
plug in.  If there is a power outage, as soon as power is 
restored it will recycle and clean itself if there is no fi re in the 
fi repot.

NOTE:  User is responsible for removing the ash from the 
ash drawer.

•  First, make sure your appliance has been properly installed 

and that all safety requirements have been met.

•  Pay particular attention to the fi re protection, venting and 

thermostat wall control installation instructions.

•  Double check that the ash pan, hopper and fi rebox are 

empty and then close the fi rebox door.

Read and understand the Thermostat 
Wall Control manual for detailed operating 
instructions.  The wall control is an intregal 
part of how to operate this appliance.

The power switch is located at the bottom right hand corner of 
the fi replace.   It turns the power on and off to the fi replace.

Before servicing the fi replace this power switch must be in 
the off position.  When the power switch is OFF there will be 
no display on the wall control screen.

Power Switch