Regency GFI55 User Manual

Greenfi re Pellet Stove and Insert Owner's Manual

MAINTENANCE

(season)

a) Open the door by lifting the handle, remove the burn pot and burn pot 

liner.

b) Before trying to remove screws, lubricate all screws with penetrating 

oil. ie. WD-40.

c) Loosen (do not remove) the four (4) screws that hold the brick liner 

retainers in place. Remove side brick liners by sliding them from 
under the screwheads.

d) Pull the center panel out. Ensure not to damage the 1" insulation 

attached to the back of the center panel.

e) Vacuum and clean thoroughly. 

a) Return center panel to its original position.

b) Place the two (2) side panels back into the firebox, secure the two 

(2) retainers and lock down by tightening the two (2) screws on each 
side.

c) Replace the burn pot and burn pot liner.

d) Close the glass door and secure.

Once you are fi nished using the pellet appliance for the season, unplug 
the stove for added electrical protection.  It is very important that the stove 
be cleaned and serviced as stated above. Also remove any remaining fuel 
from the hopper and auger. 

Painted surfaces should be wiped with a damp cloth periodically. 

It is important to note that fi ngerprints and other marks can leave a per-
manent stain on plated fi nishes. To avoid this, give the surface a quick 
wipe with denatured alcohol on a soft cloth BEFORE lighting the fi replace. 
Never clean surfaces when they are hot. Do not use other cleaners or 
abrasives as they may leave a residue or scratches, which can become 
permanently etched into the surface.

The paint on the steel fi rebox panels may peel. This is due to extreme 
conditions applied to the paint and is not covered under warranty.

The door glass is made of high temperature PYRO CERAMIC 5 mm thick. 
The center panel is 15.4” x 9.0” (39.0 cm x 22.9 cm) and side panels are 
2.6 x 9.0 inches (6.7 cm x 22.9 cm). They must be replaced with (Part # 
GF55-028 & GF55-029). Substitute materials will not be permitted.