Regency HZ54 User Manual

Page of 48
HZ54 Regency Horizon
TM
 Gas Fireplace
38
OPERA
TION
OPERATING INSTRUCTIONS
COPY OF LIGHTING PLATE INSTRUCTIONS
TO TURN OFF GAS APPLIANCE
FOR YOUR SAFETY READ BEFORE LIGHTING
 LIGHTING INSTRUCTIONS
1)  Push in gas control knob slightly and turn clockwise               to “OFF”. Knob cannot be turned from 
“PILOT” to “OFF” unless knob is pushed in slightly.  Do not force.
2) Wait fi ve (5) minutes  to clear out any gas. If you then smell gas STOP! Follow step “B” in the Safety 
Information above on this label.  If you don’t smell gas, go to the next step.
3)  Turn knob  on gas control counterclockwise             to“PILOT”.
4)  Push in control knob all the way and hold  in until the pilot lights up. Continue to hold the control 
knob in for about 20 seconds after the pilot is lit. Release knob and it will pop back up. Pilot should 
remain lit. If it goes out, repeat steps 1) to 4).  If knob does not pop up when released, stop and 
immediately call your service technician or gas supplier. If the pilot will not stay lit after several tries, 
turn the gas control knob to “OFF” and call your service technician or gas supplier.
5)  Turn gas control knob counterclock-wise to “ON”.
6)  Turn the unit on. 
A)  This appliance has a pilot which must be lighted by hand. When lighting the pilot, follow these 
instructions exactly.
B)   BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell  next to the fl oor 
because some gas is heavier than air and will settle  on the fl oor.
     WHAT TO DO IF YOU SMELL GAS
-  Do not try to light any appliance.
-  Do not touch any electric switch, do  not use any phone in your building.
-  Immediately call your gas supplier from a neighbours phone. Follow the gas supplier’s 
instructions.
-  If you cannot reach your gas supplier, call the fi re department.
C)  Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not 
push in or turn by hand, don’t try to repair it, call a qualifi ed service technician. Forced or attempted 
repair may result in a fi re or explosion.
D)   Do not use this appliance if any part has been under water.  Immediately call a qualifi ed service 
technician to inspect the appliance and to replace any part of the control system and any gas 
control which has been under water.
E)  This appliance needs fresh air for safe operation and must be installed so there are provisions for 
adequate combustion and ventilation air.
CAUTION:  Hot while in operation. Do not touch. Severe Burns may result. Due 
to high surface temperatures keep children, clothing and furniture, gasoline and 
other liquids having fl ammable vapors away. Keep burner and control compartment 
clean. See installation and operating instructions accompanying appliance.
DO NOT REMOVE THIS INSTRUCTION PLATE
WARNING: If you do not follow these instructions exactly, a fire or explosion 
may result causing property damage, personal injury or loss of life. Improper 
installation, adjustment, alteration, service or maintenance can cause injury 
or property damage. Refer to the owner’s information manual provided with 
this appliance. For assistance or additional information consult a qualified 
installer, service agency or gas supplier.
918-583
This appliance must be installed in accordance with local codes, if any; if none, follow the 
National Fuel Gas Code, ANSI Z223.1/NFPA 54, or Natural Gas and Propane Installation Codes, 
CSA B149.1. (Australia: AS5601-2004, New Zealand: NZS 5261)
STOP! Read the safety information above on this label.
1) Turn off the unit.
2) Push in the gas control knob slightly and turn clockwise      to “OFF”. Do not force.
3) Turn off all electric power to the appliance if service is to be performed.
    You may shut off the pilot during prolonged non use periods to conserve fuel.
ELEMENT
THERMO-
ELECTRIQUE
PILOT BURNER
THERMOPILE
VEILLEUSE
OFF