Sylvania SC11 User Manual
SYLVANIA Emergency Lighting
Installation Instructions
Installation Instructions for Emergency Lights
Model SC36, SC11
SAVE THESE INSTRUCTIONS
• Before Installation, read instructions and understand all safety information.
WHEN INSTALLING AND USING ELECTRICAL EQUIPMENT, ALL WORK SHOULD BE PERFORMED BY A LICENSED
ELECTRICIAN AND BASIC SAFETY PRECAUTIONS SHOULD ALWAYS BE OBSERVED INCLUDING BUT NOT LIMITED TO
THE FOLLOWING:
ELECTRICIAN AND BASIC SAFETY PRECAUTIONS SHOULD ALWAYS BE OBSERVED INCLUDING BUT NOT LIMITED TO
THE FOLLOWING:
• To prevent shock or damage, turn power off before inspection, installation or removal.
• The use of accessory equipment is not recommended and may cause an unsafe condition.
• Do not use this electrical equipment for other than its specific intended purpose.
• This unit has been supplied with specified lamps. To avoid malfunction, use only lamps specified
by manufacturer.
• The use of accessory equipment is not recommended and may cause an unsafe condition.
• Do not use this electrical equipment for other than its specific intended purpose.
• This unit has been supplied with specified lamps. To avoid malfunction, use only lamps specified
by manufacturer.
• To avoid risk of fire, do not store or place flammable materials near lamp.
• Use caution when changing or inspecting lamps as they can become hot and may cause burns if
handled improperly.
• To avoid electrocution or property damage, do not install or use where exposed directly to water or
outdoor weather conditions.
• This product contains a chemical known to the state of California to cause cancer, birth defects or other
reproductive harm.
• Use caution when changing or inspecting lamps as they can become hot and may cause burns if
handled improperly.
• To avoid electrocution or property damage, do not install or use where exposed directly to water or
outdoor weather conditions.
• This product contains a chemical known to the state of California to cause cancer, birth defects or other
reproductive harm.
WARNING
INSTALLATION
Step 1:
Remove dust cover from unit by applying gentle, even pressure around edges. If you are installing the light during a
building construction phase, please save dust cover for reinstallation to protect the unit prior to the final connection
by electrician.
Remove dust cover from unit by applying gentle, even pressure around edges. If you are installing the light during a
building construction phase, please save dust cover for reinstallation to protect the unit prior to the final connection
by electrician.