Regency I3100L User Manual

Regency Wood Insert & Hearth Heater

11

The fl ue baffl e system located in the upper area 
of the fi rebox is removable to make cleaning 
your chimney system easier.  The brick baffl es 
must be installed prior to your fi rst  fi re.  Smoke 
spillage and draft problems may occur if  the 
baffl es are improperly positioned.  Check the 
position of the brick baffl es on a regular basis as 
they can be dislodged if too much fuel is forced 
into the fi rebox. 

The Large Insert  I3100L is shipped with two of 
the secondary air tubes loose inside the fi rebox. 
They need to be installed after the brick baffl e 
are installed. Follow the directions below.

 
The unit arrives with the fi rst two air tubes (from 
the front) and the 2 baffl e bricks on the fl oor of 
the fi rebox. The baffl e bricks are positioned fi rst 
and then the air tubes are installed. 

1)  Slide the left baffl e brick over the  two rear 

air tubes and then push it all the way to the 
left side of the fi rebox. 

2)  Tilt the fi rst Baffl e Brick down and then slide 

the 2nd Baffl e Brick up and back.  Reposition 
both baffl e bricks fl at on the air tubes. 

4)  Install the two front air tubes into the holes 

on the side channels. The notch goes on 
the right hand side with the air holes facing 
forward toward the door opening.  If the tube 
will not slide in easily, simply use a pair of 
vise grips or pliers and tap it into place with 
a hammer.  A tighter fi t will ensure the tube 
will not move when the unit is burning. 

Please check to ensure that your fl oor protection 
and hearth will meet the standards for clearance 
to combustibles. Your hearth extension must be 
made from a non-combustible material.

Firebrick is included to extend the life of your 
insert and radiate heat more evenly.  Check to 
see that all fi rebricks are in their correct posi-
tions and have not become misaligned during 
shipping.  

Attach spring handle by rotating counter clock-
wise onto rod.  Ensure that the rod fi ts into the 
entire length of the spring handle.