Hearth & Home Technologies SFE-CDLB3530PP User Manual

Hearth & Home Technologies Inc. • Plug & Play • 4050-317 Rev A • 04/08

7

Projector

Lamp

S7

X1

Motor

Interlock on

Media Cabinet only

Power Supply Module

Hot Line

Ground

Neutral

Branch Circuit

12 VOC

Power

Supply

Heater

Motor

Hi Limit

Heater-Blower

Heat Indicator

LED LED LED

LED LED LED

Ember Bed & Back Log

4050-310

Wall Thermostat

4050-309

Wall Switch

Flame

Heat

Terminal Strip

ON

RD

WH

WH

RD

Remote Receiver

Flame

Heat

NEMA-5 IEC 320 C13/C14

M

M

P1

1

5

R2

R1

D1

J1

This appliance uses a single 12 Volt, 35 Watt, MR-16 bulb. 
The bulb is located behind the smoke shield.

A spare is provided with the unit. Replacement bulbs (Part 
No. 4050-123) are available through your Simplifyre dealer.

•  Turn off power to the unit at the main service panel.
• Let 

the 

fi replace cool if it has been operating.

•  Release the spring pins and remove the upper shield.
•  Remove the two screws on the projector basket.
•  Rotate the housing down to access the bulb.
•  Remove the screws holding the bulb and socket.
•  Unplug the bulb from the socket.
•  Replace the bulb.
•  Re-assemble in the reverse order.

During shipment, installation, handling, etc., the screen 
surface may collect dust particles; these can be removed 
by lightly wiping with a clean, dry cloth.

The motors used on the fan and fl ame projector assembly 
are pre-lubricated for extended bearing life and require no 
further lubrication. However, periodic cleaning/vacuuming of 
the fan/heater unit is recommended.

The heater on this fi replace is protected with a safety 
device to prevent overheating. Should the heater overheat, 
an automatic cutout will turn OFF the heater/blower. The 
switch is reset by turning the unit OFF, waiting 10-15 
minutes and switching the unit back ON.