Procom ML100HPA User Manual

         WARNING:   Maintain  the
minimum  clearances  shown
i n     F i g u r e   4 .     I f     y o u   c a n ,
provide   greater   clearances   from
floor,   ceiling,  and   joining  wall.

FASTENING  HEATER  TO  WALL
Mounting  Bracket
The  mounting  bracket  is  located
on   back  panel  of  heater (see
Figure 5).  It  has  been  taped  there
f o r   s h i p p i n g .   r e m o v e   m o u n t i n g
bracket  from  back  panel.

Removing Lower Front Panel Of
Heater
1.   Remove  two  Screws  near
      bottom  corners  of lower front
      panel.
2.   Pull  bottom of  lower front  panel
      forward, then  down  (see Figure
      6).

Methods For Attaching   Mounting
Bracket  To  Wall
Only  use  last  hole  on  each  end
of   mounting    bracket   to  attach
bracket    to   wall.  Attach   mounting
bracket  to wall only in one of two
ways:
1.    Attaching  to  wall  stud
2.    Attaching  to  wall  anchor
Attaching  to  Wall  Stud:  This method
provides   the   strongest    hold.  Insert
mounting   screws through  mounting
bracket  and into  wall  studs.

Attaching  to  Wall  Anchor: This
method  allows  you  to attach
mounting  bracket  to  hollow  walls
(wall areas between  studs) or to
solid   walls  (concrete  or  masonry).

Decide   which   method   better
suits  your  needs.  Either  method
will  provide  a  secure   hold  for  the
mounting  bracket.

Marking  Screw  Locations
1.  Tape  mounting  bracket  to  wall
where  heater  will  be  located.         Make
s u r e     m o u n t i n g     b r a c k e t     i s
level.

2.  Mark  screw  locations  on
wall. (see  Figure  7)
Note:  Only  mark  last  hole  on
each  end  of  mounting  bracket.          In-
sert  mounting  screws  through
these  holes  only.
3.   Remove  tape and  mounting
bracket  from  wall.

          WARNING:      Maintain     mini-
mum   clearances  shown in Fig-
ure 8. If  you  can,  provide greater
c l e a r a n c e s       f r o m       f l o o r
and   joining   wall.