Empire Comfort Systems VFCT25-3 User Manual

Page 8

16937-4-0806

Figure 2

Figure 3

Figure 4

When facing the front of the appliance the following minimum

clearances to combustible construction must be maintained.
Top of appliance (ceiling)

36 inches

Rear Wall 3 inches

Side Wall

6 inches

Heater Corners (45° angle) to Wall

4 inches

Floor

0 inches

CLEARANCES

Provide adequate clearances around air openings.
Adequate accessibility clearances for purposes of servicing and

proper operation must be provided.
Installation on Rugs and Vinyl

If this appliance is installed directly on carpeting, vinyl or other

combustible material, other than wood ﬂooring, the appliance shall

be installed on a metal or wood panel extending the full width and

depth of the appliance.

Assembly of Cast Iron (Outer Casing) Stove Casting

Appliance Hardware Package Parts List

Part

Quantity

Description

Number

Supplied

1/4-20 x 3/8" Phillips Head Bolt R-3646

1/4" 9/32 Washer

R-1150

10 - 24 Nut

R-1118

Attention: Included in the hardware package are (8) 1/4" inside

diameter washers. A 1/4" washer may be used with a 1/4-20 x 3/8"

bolt when assembling the stove casting parts. If a bolt hole is not

tapped deep enough for a tight ﬁt between stove casting parts, the

1/4" washer can be used as a shim to provide a tight ﬁt.
The 1/4" washers are not required for assembly of the stove casting

if all the bolt holes are tapped to a proper depth.

1. Remove casting from shipping carton. Place casting on non-

abrasive surface.

2. Remove burner assembly, logs, hardware and sheet metal

parts from shipping carton.

3. Attach rear cover to casting sides with 1/4 - 20 x 3/8" bolts

(2 per side) as shown in Figure 5.

4. Attach casing bottom to casting sides with 1/4 - 20 x 3/8"

bolts (2 per side).

5. Align and place (2) clearance holes on front legs of burner

assembly over (2) rear weld studs in casing bottom.

6. For VFCR-25 only, attach green wire to the TH terminal on

gas valve. Attach black wire to the TH/TP terminal on gas

valve from wiring harness on valve cover plate.

7. Attach three (3) knob extensions onto gas valve as shown in

Figure 6.

8. Align and attach (2) clearance holes on MV switch bracket as

shown in Figure 6 onto (2) front weld studs in casing bottom

with (2) 10-24 nuts.

9. Attach casting front onto casting sides as shown in Figure